No products in the cart.
Guide: How to make your injection of HGH, peptide, EPO and HCG a success!
Preparation of a vial Peptide, Growth Hormone, EPO or HCG before injection
Pharmaceutical companies do not produce hGH / Peptide / EPO / HCG in a ready-to-use form. So it is essential to know how to prepare it to be able to administer it. These products must absolutely be prepared in the right way and the type of dose varies according to the patient.
The preparation has been simplified to allow everyone to prepare their dose with great ease. The elements used for the preparation of a vial can be purchased on the Internet (see our accessories) or in a pharmacy (depending on the country).
The necessary elements are:
- 2 wipes soaked in alcohol
- Your peptide vial, hGH, EPO or hCG
- 1 bacteriostatic (or sterile water) vial of 2, 3 or 5 ml, depending on the required dosage
- a 3 CC syringe with a measurement of 25 units (is not essential, but this syringe can be used first to remove the bacteriostatic water and add it to the vial of Peptide / hGH / EPO / HCG)
- an 1 ml insulin syringe for subcutaneous injection
- Sterile rubber gloves (optional)
When you have all the elements required before you, you can start preparing:
- Wash your hands thoroughly with soap and water (then rubber gloves).
- The vials have protective plastic plugs: do not forget to remove them. After removing them, you will have access to the rubber stopper.
- Use alcohol-wiped wipes to sanitize the rubber stopper. Rub the wipe gently on the cap. (This step is not mandatory because the vials are sterile, but if you want to do it for even more precaution, this is not a concern).
Now you can mix the bacteriostatic water and the hGH / Peptide / EPO / GCG: open the package that contains the 3CC syringe and remove the cap that is on the needle (before removing the cap, press it gently on the needle that is still hooked to make sure it is attached correctly). When you have removed the cap, insert the needle into the vial of bacteriostatic water. Then, hold the vial slightly upward and draw the bacteriostatic water into the syringe.
- When all the water is in the syringe, you can now mix it with hGH (or peptides / EPO / HCG). Carefully insert the needle into the vial, taking care to find the appropriate angle so that the needle touches the wall of the vial and flows towards the powder.
When the desired amount of water is in the vial, you can turn the needle to remove it and replace the cap on the needle. Next, discard the 3CC syringe.
- Once the bacteriostatic water is in the vial, you will notice that the powder begins to dissolve slowly. To speed up the process, you can put the vial in your hands and roll it slowly forward and backward. When the powder is completely dissolved, after about 15 seconds, you will get a clear liquid. Never shake the vial.
- The white powder must absolutely be dissolved (usually instantaneous but you can wait 5 or 10 minutes to be sure). HGH (or peptides / EPO / HCG) in liquid form is now ready to be injected.
How to make a subcutaneous injection of HGH, peptide, or EPO HCG?
Normally, depending on your goals and your profile, a dose of hGH ranges from 2 IU to 6 IU in general. To know the perfect dosage, you must refer to the instruction manual of the laboratories or consult our expert free.
- Take the 1 ml syringe out of its box.
- Remove the protective cap that is on the syringe.
- Insert the needle directly into the rubber stopper, while holding the vial in the correct angle, with the lower part pointing upward.
- When you have the required dosage in the syringe, you can inject it. The injection should be done at the abdomen, only at 5 cm of the navel. Squeeze the skin that has the most fatty mass and clean it with a wipe soaked in alcohol.
- While you pinch your skin and greasy masses, insert the needle with an angle of 45 degree.
- When the needle is inside your skin, you can release the skin fold and push the suction cup slowly to inject the solution.
- When the solution <> has been completely injected, you can remove the needle and put the cap back on.
- Discard the syringe into a container for sharp objects.
The preparation and injection of hGH (or peptides, EPO or HCG) is very simple, everyone can learn to inject (or inject someone) in minutes.